Life-fitness Elliptical Trainer Manual de usuario

X 5 TOTAL-BODY ELLIPTICAL CROSS-TRAINERASSEMBLY INSTRUCTIONS

9

SETUPTools required: Socket set, Phillips Screwdriver, 9/16" open end wrenchPlease read instructions carefully before assembly. Be sure to assemb

4. Insert two (#4) 5" bolts and two (#7) washers into the back-side of the connector joint on the base frame (B). Connectwith two (#7) washers an

STEP 41. Attach front shroud (E) to base-frame (B) using eight (#1) Phillipspan head screws (4 on each side). Using a Phillips screwdriver,secure the

STEP 5Attach Plastic Upright Cap to upright assembly:1. Push the Plastic Upright Cap (F) into the open end of the tube at the topof the upright tube a

STEP 6Attach accessory tray to upright assembly:1. Feed the upper wire harness (G) through the slot in the accessory tray bracket (H).2. Line up the h

STEP 7Plug cables into the back of display console:1. Plug the 10-pin connector at the end of the upper wireharness into the 10-pin connector (10P) in

STEP 8Attach the display console to the console plate:1. Line up the four holes in the back of the console plate (J) withthe four holes in the back of

STEP 9Connect the pedal levers to the upper arms:1. Insert pedal lever (L) into the clevis bracket (M) of the upperarm (N).2. Connect the pedal lever

HOW TO STABILIZE THE LIFE FITNESS CROSS-TRAINERAfter placing your Cross-Trainer where it will be used, check its stability.If there is even a slight r

CORPORATE HEADQUARTERS5100 North River RoadSchiller Park, Illinois 60176 • U.S.A.www.lifefitness.comINTERNATIONAL OFFICES8117401 Rev A-108/061LIFE FIT

5100 N. RIVER ROAD, SCHILLER PARK, ILLINOIS 60176LIFEFITNESS.COMLife Fitness offers a full line of premier fitness equipment for the home.TOTAL-BODY E

Before using this product, it is essential to read thisENTIRE operation manual and ALL installation instructions.This will help in setting up the equi

TABLE OFCONTENTSImportant Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

This Manual describes the assembly of the following products:Life Fitness Cross-Trainer:X5Statement of Purpose: The Cross-Trainer is an exercise machi

BEFORE ASSEMBLING CROSS-TRAINERDO NOT locate the Cross-Trainer outdoors, near swimming pools, or in areas of high humidity.DO Make sure the sides, fro

IMPORTANTSAFETY INSTRUCTIONS• WARNING: Safety of the Cross-Trainer can be maintained only if it is examined regularly for damage and wear. Keep this p

• Keep all loose clothing, shoelaces and towels away from moving parts.• Keep the Life Fitness product away from walls and clear of any obstructions a

PARTSDESCRIPTION1 Phillips Pan Head Screw – Clevis Cover & Front Shroud Fastener . . . . . . . . . . . . . . . . . . . . . . . . . . . . Qty: 1210